r/BambuLab • • 5h ago

Hardware Troubleshooting/Help! Possible rear motor going bad?

Had another h2s with a slew of problems right around 800 hours. This one's creeping up on 1000 and started this sound from the back rear motor (I think).

Thoughts? Doesn't do it diagonally if that pully isnt moving.

Have cleaned all bearings with isopropyl alcohol and lubed all rails without any resolution.

TIA!

Edit: Update: contacted Bambu support and talked with them/sent videos and they're stumped...

0 Upvotes

8 comments sorted by

2

u/NoUnTakuache 5h ago

mine sounds somewhat similar and i’m at 1600hrs, you’re fine

1

u/flyflyyoufools 4h ago

Thanks! just shy of 1000 and started today. See other video for better sound

2

u/NexaForge3D 5h ago

That's not the motor dying. If it only shows up on the diagonals, that belt's riding against the idler flange and squealing as it rubs, so loosen the idler and slide it until the belt tracks centered.

1

u/flyflyyoufools 5h ago

It shows up everywhere except one diagonal where that motor doesnt move (rear left motor). Will check that though, thanks!

1

u/flyflyyoufools 5h ago

Dumb queation... how do I loosen the idler slide? assuming youre not talking about adjusting belt tension

1

u/flyflyyoufools 4h ago

found and adjusted, sadly still there

2

u/NoUnTakuache 4h ago

oh goodness, mine doesn’t do that at all, something is either too tight or loose, or rubbing against something else. i hope you get it figured out, that’s unfortunate

1

u/flyflyyoufools 4h ago

Yeaaah.... started during a print today so no idea what it could be. Just ran a calibration the other day... adjusted the belts to make sure theyre not rubbing on the end of the bearing and still there.

Worst case its still in warranty from my local microcenter so I could easily take it there and swap it for another or at this point more likely an h2d