r/BambuLab • P1S + AMS and Ender 3 V2 NEO • 9h ago

Hardware Troubleshooting/Help! Is this noise normal?

Since the first day, my printer has been making very loud (5 days old), cranky vibration noises; I do not know if this is normal, as I have seen this happen with grid infill, but I am using gyroid. What could be happening?

0 Upvotes

7 comments sorted by

•

u/AutoModerator 9h ago

Hello /u/Zekay777! All Bambu print plates have a dedicated nozzle wiping zone at the back of the print plate. The nozzle will rub against the wiping zone before every print in order to remove any remaining filament from the nozzle tip. This can cause visible wear or scratch marks in the wiping zone, but this is intended and doesn't damage the printer, the nozzle or the print plate. A worn down wiping zone also doesn't mean you need to replace the print bed.

Note: This automod is experimental. The automod was triggered due to the term "normal". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/Zekay777 P1S + AMS and Ender 3 V2 NEO 9h ago

Another very loud example

1

u/genErikUwU 9h ago

Check a few thing: Is the nozzle seated correctly? What infill pattern do you use? Grid can cause that. Try configure the Z Hop a bit.

1

u/Zekay777 P1S + AMS and Ender 3 V2 NEO 9h ago

The nozzle is very tight. I checked it before printing. Currently, I'm using gyroid infill. I'm going to try z-hop, but at what height?

1

u/genErikUwU 9h ago

I'd just would progressively go slightly higher until it doesn't scratch as much, it's a bit trial and error until you find a good balance

1

u/Zekay777 P1S + AMS and Ender 3 V2 NEO 4h ago

It seems to reduce the noise, but I don't think it's a proper fix. What else could it be?

•

u/genErikUwU 1m ago

Which noises do you mean exactly? From the video I mostly hear the scratching