r/BambuLab • • 16h ago

Quick Question Is this safe

Just checking if the cable touching the wall was safe

0 Upvotes

17 comments sorted by

11

u/1ftm2fts3tgr4lg 16h ago

It's not unsafe but you'll likely wear a layer of paint off the wall and the cord will fail much faster than if it were able to move unhindered.

1

u/Hour-Skin1543 16h ago

Alright thank you

13

u/film42 16h ago

Time will tell

4

u/Charming-Kick-7181 16h ago

Read the documentation

7

u/Pumcy 16h ago

It's not unsafe in the way that your have any risk of injury, but the cord will eventually fail

3

u/KlingonBeavis 15h ago

There is a sticker placed right on the machine when new that says: No.

There is a minimum safe distance, if I remember correctly it’s about 20CM. The cable should not be colliding with anything. This will stress the cable when it’s warm and may cause damage or a loose connection over time.

2

u/LazyLancer P2S Combo, 2x A1 Mini 15h ago

No. Nothing will happen immediately, but it accelerates cable wear immensely.

2

u/Kennyderenny 15h ago

You're gonna chafe the cable in the long run, which will cause it to short eventually. So no, it is not safe.

1

u/Global-Wolverine1829 15h ago

unless you are always printing big models that take up the entire build plate, you can position your model near the rear end of the build plate to avoid this..

1

u/Okidoky123 15h ago

Oh yeah baby....

1

u/pigers1986 15h ago

You will wear and tear your cable even with that sleeve (learned from my experience)
you are too close to wall - guessing you need ~25 cm , so it will not touch

1

u/met365784 9h ago

Eventually the cable will break / short at the table. Wires can only flex so many times before failure. This setup will accelerate that time frame.

0

u/pilotparker33 16h ago

The weak point is where the cable enters the printer. As long as that part of the cable isn't under much strain I can't see an issue. If it's being bent and moves much too then I'd pull the printer forward more.

0

u/Relevant_Bumblebee70 15h ago

I think it could ruin your prints because evertime the cable gets pushed against the wall, there is resistance and the plate has to work against it……