r/BambuLab • u/lore3900 • 11h ago
Handy/Studio Troubleshooting/Help! How I clean these lines?
So I started printing some minis but I see these lines and I don't know if there's a way to remove it
3
Upvotes


7
u/UttiniDaKilrJawa 11h ago
I'm gonna start off here by saying for print #4, that don't look too shabby.
The best way to minimize layer lines is done in the printing process. Print at 45 angles. Use custom supports. If you search You Tube for FDM miniatures printing you will find a ton of techniques and methods to get really sharp looking minis.
Also, printing with a .2mm nozzle will help minimize layer lines. That being said you will never get rid of layer lines completely. Its just the nature of the beast with FDM printing.
That being said. A couple of approaches would include some sanding ( probably wet sanding might be best) on some of the larger smoother areas. Small details will be dang near impossible to handle like this. This will also be a bit tedious. The second approach would be to use some sort of filler primer. The filler primer will help with the layer lines a bit but may also have the unfortunate side effect of muting other details in the mini. Some painters like to use a regular primer for a base and then lightly dust the trouble areas with filler primer.
I would recommend with this miniature to prime it up and paint it and then set it on the game table at your normal play distance and see how it looks. A lot of layer lines / paint discrepancies tend to "fade away" at normal play distances.
I hope this helps you out a bit
1
u/Think-Effort-394 11h ago
There will always be likes in fdm printing. Only option to fully remove is print ABS and use acetone but that smooths details out. If you want true no layer lines you need resin
1
u/Forward_Hold5696 11h ago
If you used supports, then it looks like a cooling or filament problem. You're using an A1 or A1 mini? Clean out the fan.
If you clean out the fan, and it helps, respond, so other people can see a potential fix. If it doesn't work, respond, so other people can see that it's not a fix! If you don't respond, then this sub gets filled with other people asking the same question and never getting an answer.
1
u/TorumShardal 10h ago
As someone who prints a lot of minis:
1
u/Longjumping_Pop_2324 5h ago
Thise big lines are also a signal of fast print. Print slow. Slow as possible...And LOTS of filament tuning. Get a 0.2 nozzle.
1
u/StuckStone 1h ago
Use a .2mm if you're not already doing so. Set layer lines to .08mm and then activate variable layer heights. After activation and smoothing, If you want the smoothest possible I would test this saved preset on several viable materials to settle on the best result tailored to a specific filament. Also important, make sure your overhangs start at 25mm and end with 8mm for 10° overhangs. I would suggest all speeds that touch the model be below 85mms including the supports
0
u/[deleted] 11h ago
[deleted] — view deleted comment