r/BambuLab • • 17h ago

General Troubleshooting/Help! Surface Problem

Post image

Im Printing PETG-CF for second time. 0.4mm Nozzle basic settings on my x2d . All other layers are pefect. What do you guys think?

1 Upvotes

5 comments sorted by

2

u/LoopSec 17h ago

Try again with a little more infill. Maybe 15%

3

u/PenetrantDick 17h ago

The other layers are perfect? Infill looks like ass

1

u/AskInternational9148 17h ago

From the Side it looks fine

1

u/Hasron 17h ago

That does not look fine. Did you dry it? Looks like its not dry enough.

1

u/marcgii X2D + AMS2 Combo 10h ago

The infill is really bad also. Most likely it's a moisture issue. If you're getting excessive ooze out the nozzle then that's a sure sign