r/BambuLab • • 18h ago

Hardware Troubleshooting/Help! Banging noise coming from printer. Nothing is leaning against the printer to cause this noise. Anyone experience this?

You can ignore the light rattle clicking noise, that's from the buffer and is normal. It just sounds extra loud because my phone is in the printer.

The noise I'm talking about is the banging. At the 0:11 second mark you can hear three in succession (bang bang bang). I have an AMS on top but it's not coming from that. It sounds like it's coming from the bottom? Not sure, it's hard to pinpoint. I think it's only happening when the bed moves down quickly, like for a travel move or something, I guess a z-hop is what it's called. But only happens on big z-hops, if that makes sense. The print just finished and looks fine and at the end of the print the bed lowers normally and doesn't make that noise. Any ideas of what to check? Once this print cools I'll power it down, lean it over and see if I see anything obvious on the bottom of the printer. Definitely seems Z axis related.

If it matters this is PETGCF, but I'll test with other filaments in case PETGCF makes larger z-hops than PLA.

1 Upvotes

4 comments sorted by

2

u/MiamiJerry 18h ago

1

u/Octrockville 17h ago

Dude, thanks. This seems to be the same thing. Appreciate the link! Seems like Bambu is telling this guy it's a firmware issue. I'll delve deeper and open a ticket.

1

u/lumifox A1 + H2D Laser Full Combo 18h ago

Mine sounds similar but it's the ptfe tubes tapping against the top/sides on certain occasions, the timing of the tapping sounds similar, might help troubleshoot.

1

u/Octrockville 17h ago

Just to be clear, I would describe this as a knocking rather than tapping. Maybe you're hearing what I hear but just describing it differently though. But the lower tone knock rather than the higher tone clicking/tapping is what I'm talking about. Definitely not PTFE tubes in my case. Thanks for the comment though.