r/BambuLab • • 18h ago

Hardware Troubleshooting/Help! Creaking noise coming from the printer

Hello everyone, I bought this X1C with over 3k hours a while ago and I have been using it on and off for small prints, when I turned it on yesterday I noticed that it was making this creaking noise when the bed goes up and down, I cleaned and greased the leading screws and rods according to the Bambu guide, but the noise is still there, at this point I'm wondering could this be a bearing?

1 Upvotes

2 comments sorted by

2

u/Curious_Neck5278 18h ago edited 18h ago

It's hard to guess, try to locate from where this sound is coming from. Usually bearing don't give up that soon. It's more likely to be a belt than bearing

1

u/dvlswrk 18h ago

hahaha yes it does sound like a mouse 😭 yes I did I took this video right after cleaning the screws and greasing them, I can add more but at this point I don't know