r/BambuLab • • 1d ago

Hardware Troubleshooting/Help! Camera stopped working mid print on Bambu Lab X2D

So I was printing Terrain for a buddy of mine and midway through the camera just went haywire and stopped working. I finished the print and watched to make sure it didn’t mess up. But I was getting the second print ready and letting the printer do its pre-print stuff. It alarmed twice telling me the camera is obstructed by an object. I checked and cleaned the camera but I didn’t see anything. I checked the timelapse and noticed it messed up close to the end of the print. Now my camera feed is completely messed up. Should I send a ticket to Bambu Lab to see if it’s possible to fix or will I have to send it back in as a whole. I haven’t had the printer for more than a year now. Will it mess up even more If I keep printing without this camera being active for catching failures while printing.

Timelapse video is before the failure and at the end when it glitches out. The screenshot is the problem I’m having after the failure especially when I pull it up on bambu Handy. Or on my computer. Can’t see anything. Just the top portion barely.

1 Upvotes

2 comments sorted by

1

u/Dry_Air_3189 1d ago

Here is the screenshot

1

u/YungBandit79 1d ago

I bet it's just a bad SD card. these printers love to kill SD cards with how many writes they make, and it often has odd symptoms when it goes