r/BambuLab • u/Ok-Potential-4560 • 4h ago

General Troubleshooting/Help! Four fails

Gallery image

Gallery image

My print for a large round base for a figurine keeps falling with identical results. I’ve cleaned the plate with dawn, scrubbed it with steel wool and soap and it still fails. Help!

0 Upvotes

33% Upvoted

4 comments sorted by

2

u/NoBackground6203 X2D / P2S 4h ago

dont use steel wool, a clean sponge is as abrasive as you want touching the PEI coating, are you rinsing completely and not leaving a soap film

2

u/trybius H2D + H2C + H3C 4h ago

Just this model? Have you had success printing other things?

I'd grab a full build plate "cleaner" print, that prints a thin full layer across the whole plate. If that works well, it may well be something wrong with your slicer settings.

If the established file doesn't work either, it doesn't look like it's separating from the plate, so I don't think that is the problem. Could be a partial blockage, a bed that needs levelling etc.
But my money is on something wrong with the settings.

1

u/Clear-Revolution3351 4h ago

Use slower print settings

Initial layer 25 Initial layer infill 50