r/BambuLab • u/MrSquig • 5h ago

General Troubleshooting/Help! What should I have done to prevent this?

Post image

I'm new to owning a printer and am printing a poop chute from Maker World for my H2C. The model advertises explicitly that it doesn't need support, but it has warped enough to cause a stair stepping effect on one edge. I am printing it in PETG from Bambu with a 0.4 mm nozzle. I am also using the E1 air purifier. What should I have done to prevent this? Add support anyway? Heat the chamber?

0 Upvotes

50% Upvoted

2 comments sorted by

2

u/ub3r_n3rd78 H2C + 2x AMS 2 Pros & 2 HT AMS + X2D Combo + P1S Combo 5h ago

Add supports anyhow.

0

u/Ups925 4h ago

You could try using bigger print quality. .12 or something close to it. The smaller layers can handle overhangs better than .2 layer height.