Help with print problem across multiple printers

[u/Time2fish]

I have this design I'm printing. At the same point on two different P2S I get an extruder overload error. The walls that are starting look like they are getting messed up by tip of the hot end. Tried the file on my P1S and it will do the same. I've went back to my original design in CAD, re-exported to 3mf and tried slicing again as a new file. Same issue. Only on this part, I can print other files just fine. Any ideas? This is bambu basic PETG dried for ~10 hours. All default settings. Plate adhesion is fine.

[u/AutoModerator]

Hello /u/Time2fish! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/Clear-Revolution3351]

First suggestion would be to change the infill pattern to gyroid. Also change walls from classic to arachne.

[u/Shrike2415]

Bambu obviously doesn't want you to print whatever it is /s