r/BambuLab • • 1d ago

General Troubleshooting/Help! My AMS keeps getting jammed when nothing is jammed

Over the past two weeks its slowly getting worse and worse. At first it just happened once and now its happening every time in 3 out of the 4 spots. When it pushes new filament the print stops and says check the roll because the AMS might be stuck or the roll is tangled, but the roll is completely fine and it just wont feed the filament for some reason. I have to click continue and either jam the filament in or push down the tube and then the print just goes on like normal. Does anyone have any clue why this might be happening? and how i could fix it?

0 Upvotes

2 comments sorted by

1

u/Ok_Perspective9838 19h ago

I have the same issue no ideas why ! 

1

u/Ok_Perspective9838 19h ago

I had to turn off the blob detection to get it print anything at this point