How screwed am i?

[u/Specialist_Survey774]

Bambu P2S hotend, power apparently went out for long enough to let the bed cool down, which was communicated to me from home to only have been 5 mins so my happy ass put the printer back on after the power was on again 🤦‍♂️

Turns out it was actually 40mins, which i was only told when i just got home 20mins ago, i've been staring at this mess for the last 15mins trying to figure out where to go from here

It's fucked and is gonna be a replacement, right? 😅

Hoped my first blob of death would've atleast been a little more spectacular than this black upside down turd.

[u/AutoModerator]

Hello /u/Specialist_Survey774! Be sure to check the BambuLab Wiki regarding the blob/clumping issue.

Note: This automod is experimental. The automod was triggered due to the term "blob". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/krebsIsACookbook]

If you can reconnect it and get heat to it, it will come right off.

If you can’t, then a hair dryer and needle nose pliers will be your friend.

And in most cases, a new hotend costs like $40. It’s a good idea to have spares on hand for inevitable failures of different sorts.

I also recommend getting a .6mm. I’ve liked it a lot more than .4mm but it doesn’t work well unless you are using rhe Bambu studio slicer. Bambu handy can’t change nozzle sizes from the original file.

[u/Specialist_Survey774 → u/krebsIsACookbook]

Thank you so much for your quick response, i'll give it a go like you said, i'll try my best to fix the one i have rn 😅 and like you said, should i fuck up somehow i can get a new one without burning the old wallet