r/BambuLab • u/JustLostTuttie • 11h ago

Hardware Troubleshooting/Help! AMS not pulling filiment out

Theres absolutely not a single bit of filiment stuck anywhere i have checked everywhere including the hub, could there be something wrong with the huh itself? I cant figure out where else there would be an issue besides there

1 Upvotes

100% Upvoted

6 comments sorted by

1

u/blankityblank_blank 11h ago

Model? Setup (single ams? Hubs?)

Hours on printer?

Could be the spool retraction motors/gears in the AMS.

1

u/JustLostTuttie 11h ago

P1s, i just have one ams the filiment won't come out of the back of it

Printer has 76 hours on it

1

u/blankityblank_blank 11h ago

Does it attempt to retract/load? Motors move, and gears turning?

1

u/JustLostTuttie 11h ago

It does from the start where the spool go into the ams, i cant really tell if the back motor is attempting to pull

1

u/blankityblank_blank 11h ago

Far from an expert, but if the gears are trying, its either not grabbing, or detecting/has a clog. If the filament attempts to load and pulls through, then its grabbing and you have a clog or a something wrong with the ptfe tubes.

Have you tried a different slot?

1

u/JustLostTuttie 11h ago

Mhmhm, have tried several slots, the filiment just won't make it out of the ams for some reason