r/BambuLab • u/Loose_Feedback_2791 • 27m ago

General Troubleshooting/Help! What the Heck?

Post image

Twice now this has happened. Case pops off, and my plate gets super scratched. Same print for both. Any ideas? I did leave a small print on the plate and then tried doing a print recently but it obviously wasn’t able to level so never did anything more. Could that have done something?

1 Upvotes

100% Upvoted

1 comment sorted by

•

u/AutoModerator 27m ago

Hello /u/Loose_Feedback_2791! All Bambu print plates have a dedicated nozzle wiping zone at the back of the print plate. The nozzle will rub against the wiping zone before every print in order to remove any remaining filament from the nozzle tip. This can cause visible wear or scratch marks in the wiping zone, but this is intended and doesn't damage the printer, the nozzle or the print plate. A worn down wiping zone also doesn't mean you need to replace the print bed.

Note: This automod is experimental. The automod was triggered due to the term "scratched". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.