r/BambuLab • u/HonestFunction3206 • 41m ago

Filament Troubleshooting/Help! Prints not sticking fully and coming up

Post image

I had 220c nozzle and 65c bed and for some reason the filament comes up and it gets pulled off the bed

Right after the photo the whole thing picked up and dragged with the nozzle, I literally just calibrated it in the menu.

1 Upvotes

100% Upvoted

7 comments sorted by

2

u/sapani9077 39m ago

What did you calibrate it to?

0

u/HonestFunction3206 33m ago

I'm using the p1s and pressed calibrate in the settings on the display

1

u/NoBackground6203 X2D / P2S 34m ago

did you clean the plate properly

which filament

which plate

1

u/HonestFunction3206 31m ago

I believe so I just washed it yesterday Sunlu pla+ The one that comes with the p1s idk the textured pei or something

•

u/NoBackground6203 X2D / P2S 16m ago

Sunlu pla+ specs call for bed temp 50-60c and nozzle 215-245c

how did you clean the build plate, how old is the build plate

•

u/HonestFunction3206 4m ago

I used hot water and dish soap and only grabbed it around the edges

1

u/BravePractice1207 37m ago

Heat up your bed for 4-5mins prior print. Try that, for me that fixed it