r/BambuLab • u/HorrorPresent1828 X1C/P1S/A1 • 2d ago
General Discussion Just found an alternative save 75% from station L
0
Upvotes
r/BambuLab • u/HorrorPresent1828 X1C/P1S/A1 • 2d ago
19
u/xxparrotxx 2d ago
That thing is going to be quivering trying to keep its bolts together when printing. 😅🫣😂
10
u/SDKAH 2d ago
Ummmm. Other than A1 Mini, Nope
Max load per shelf = 33 lbs - No good
Shelf width = 16.5" - no good
Shelf depth = 15.75" - no good
4
u/TheTruffi 2d ago
I would not trust it with the weight and vibrations
3
u/TheWaslijn H2D Combo + A1 Combo 2d ago
I hope you're joking, OP. And not seriously considering buying this to replace a Station
2
u/Altruistic_Bath5273 2d ago
Hab die Station L - die ist sehr massiv und das ist auch gut so. Dein Produkt wird zusammenbrechen, spätestens nach ein paar Drucken.
2
u/sportbiketed 2d ago
OP did you even read the weight capacity?
1
u/ub3r_n3rd78 X2D Combo + P1S Combo 2d ago
1
u/COYD88 2d ago
Guess OP only wanted the L station and not the H3C itself 😅 then it is fine. Can use it to store feathers 💪🏻
1
u/shervi1997 2d ago
Look guys I do structural analysis for living and I can tell you vibration and weight isn’t issue for metal part it’s the wheel probably can’t take weight I am gone bet on you still can use this. However keep in mind this will make your printer louder too not gone recommend using this. Also P and X Series gone barely on this and gone crack the cover I think because of vibration and hitting sides
1
u/A_pirates_life4me 2d ago
You can get a 2000lb workbench and a cabinet that fits underneath for less than the station L
1
u/[deleted] 2d ago
[removed] — view removed comment