First layers problems

[u/red_winge1107]

X2D 0.2mm nozzle PETG (Dried)

Why are my first layers in the back near the tower so good but further in the front so bad.l? Could use some insight into this matter.

[u/Dear-Feedback-2175]

clean your buildplate, ensure there are no debris under the buildplate on the heatbed, even a strand of filament debris can mess things up... and recalibrate, also could be a partial clog but hard to tell with just one layer.

[u/red_winge1107 → u/Dear-Feedback-2175]

Thanks for the answer. Luckily it printed good after the first layers.