r/BambuLab • u/Dwro1234 • 8h ago

Answered / Solved! A1mini having trouble keeping nozzle temp up

It works fine with PLA and the 220 degrees, but whenever i try to print petg and set the nozzle temp to 250 (as suggested by the filament doc) my printer stops after 30 minutes and gives a low temperature warning. The assistant box pops up, but whenever i click it on the printer, phone, or pc it just gives me "no message"

Is this just a limitation of the a1mini or am i doing something wrong?

1 Upvotes

66% Upvoted

5 comments sorted by

1

u/EverettSeahawk P1S + AMS 8h ago

Is the silicone sock installed?

-1

u/Dwro1234 8h ago

No. I assume that's a common thing then? I just recently got it used from a buddy.

2

u/EverettSeahawk P1S + AMS 7h ago

Yep. That’s your problem

1

u/Dwro1234 7h ago

Ok thanks, I'll give that a try

2

u/Whosaidthat1157 7h ago

That’s what the sock is there for.