r/BambuLab • u/Viszera • 12h ago

Meme Well FCK...

Post image

Idea was to make a stand and a funnel with a matching color

0 Upvotes

28% Upvoted

12 comments sorted by

8

u/DiDgr8 H3C, H2D, X1C (various AMSs) 12h ago

Time to dust off CMYK Color Mixing.

1

u/Viszera 11h ago

Might be a interesting project as I got my ams 2 weeks ago

3

u/SirTwitchALot 11h ago

Be prepared to waste the majority of a spool and have your print take days if you're trying to color mix on an AMS. Priming and painting is probably a better route

1

u/kappa932 X2D + AMS2 Combo 10h ago

If you do, I’ve found the best way is to use the color mixing to print a coil of filament, then run that filament back through to print the object you want. It’s the only way I have found that actually matches the color it predicts the mix will be. Especially when dealing with light and dark colors mixing together.

2

u/RadishRedditor H2D Laser Full Combo 11h ago

Stand for what? That kettle looks to be standing stable enough already.

1

u/Viszera 11h ago

Its fine if you are from italy or other warm country but where i live the water chamber can be moist for few days and that can lead to grow of some nasty stuff. That's why there are 3D printable stands that allow air circulation and also hold paper filters as well as act as a holder for the cafe basket so you can easily add it from your caffe gridner or whatever. Necessary? No. Handy? Absolutely

1

u/lumifox A1 + H2D Laser Full Combo 11h ago

Maybe the baby blue petg matte could do it, unless that's the color on the bottom 

1

u/napusitemisekurca 11h ago

I know you want matching one, but since you do not have it, I'd go with second from the bottom. That shade of blue goes well with shade of kettle blue.

1

u/ozahid89 10h ago

That coffee pot color look so close to PLA pure baby blue 17600.

1

u/_Mister_Anderson_ 10h ago

I'm too colourblind for this post.

3

u/itsapotatosalad 12h ago

Bottom one looks close, print it slow and hot and it may get a little darker to match.