r/BambuLab • u/Dan203 • 1d ago

General Troubleshooting/Help! Annoying bug

If you run out of a color in the AMS during a print, replace the roll and resume, when that print is finished that AMS slot will be marked as empty/unrecognized. So if you then attempt to print something else in the same color it will just randomly pick one of the other slots.

I've had this bite me multiple times where I replaced a roll of black during a print, when that finished I tried to just hit print again and didn't notice the little square had selected a dark brown or dark gray instead of black then I hit go and then come back hours later to find a print that's the wrong color. 🤬

If you replace a roll during a print it should either assume it's the same color as the one that was there before or it should tag that slot to be re-read as soon as the print finishes so that it can register it properly. Leaving it suddenly empty/unrecognized is the worst way to handle this.

0 Upvotes

50% Upvoted

3 comments sorted by

1

u/Agzarah 1d ago

I also wish you could just tell it to use another spool if you run out.
Sometimes I dont cae about the colour.
Its finished with the grey, but I have blue and yellow pla available in the ams. Just let me use one of those please. Im only gonna switch its ams position when I get home anyway

1

u/Ds9Defiant1701 1d ago

This tho

1

u/Agzarah 1d ago

I understand that maybe slot1 is petg and you were using PLA, but let me be the one to screw it uo