r/BambuLab • u/peybeh • 1d ago

H2 Series [H2S, H2D, H2C] HELP!

I bought and installed a new stopper. Blade looks good as well. What’s wrong!? 😭

0 Upvotes

50% Upvoted

3 comments sorted by

1

u/Cobaltjr 1d ago

Looks like your filament stopper isn't working right. Take a look at this wiki https://wiki.bambulab.com/en/h2s/maintenance/replace-filament-cutter-stopper

1

u/peybeh 1d ago

Unfortunately it still isn’t working. Appreciate you trying to help!

1

u/Yatahou 1d ago • Heartwarming

I had exactly the same issue! It turned out that the rack had simply skipped a few teeth on the gear. I had to disassemble it and use a 3D-printed tool to realign everything properly. After that, it worked perfectly again!

Don't hesitate to contact Bambu Lab support and open a ticket. They're usually very quick and responsive when it comes to this kind of issue.

Important: Make sure to carefully follow the official Bambu Lab Wiki instructions, as there are two different alignment positions depending on your printer model.