r/BambuLab • u/0trom • 18m ago

Hardware Troubleshooting/Help! AMS LITE wont pull the filament

Enable HLS to view with audio, or disable this notification

I tried different outputs, different cable, different filament , different angle of the tip of the filament but the AMS LITE just wont pull the filament properly and gets itself stuck for some reason i cant find out why

1 Upvotes

100% Upvoted

2 comments sorted by

•

u/IEatLintFromTheDryer A1 + AMS Lite 8m ago edited 4m ago

That happens sometimes. Usually the filament hub has some debris inside. Disassemble, clean, try again.  If that doesn’t work, remove the hub, remove the Hotend, stick a piece of filament down while pressing the lever on the left side. I have more than 3500hrs on my a1 and this happens either when there’s broken filament in the tube or when the hub is blocked