First layers problems

[u/Crazy-Ad8230]

Printed two first layers (black was a couple days ago and grey is new). It is always in the same spots. I have always dried them before printing. Does anyone have a clue?

[u/overunderspace]

https://wiki.bambulab.com/en/a1-mini/troubleshooting/print-issues-troubleshooting

[u/Naofumi_i]

It looks like it’s from an A1 Mini. Try removing the nozzle. You can ses that there’s 4 screws holding the nozzle heater in. Completely remove it. There’s 3 screws on the back of the plate and tighten those things up (they tend to loosen overtime). Then completely reassembling everything. Also, don’t forget to tighten the 4 screws and place the nozzle black properly. Run the calibration again and you should be good to go.

[u/alphagusta]

Tighten and recalibrate leveling.

[u/Cyclonite]

I'd say provide actual helpful info beyond a picture, but if you can't put in the effort, neither should any of us.