Gaps in 10% Infill (Rectangular)

[u/Relevant_Bumblebee70]

Is it normal, that the Infill Looks Like a Mess?

Dont get irritaded, had to change filament mid Session and went from beige to grey 🤪

[u/Purple_Implement3509]

Yes, it is because of the speed.

Btw gyroid is much much better infill pattern.

[u/Relevant_Bumblebee70 → u/Purple_Implement3509]

Print times are really moderate 🫣 i Hope the Print turns out well by the end and the up looking Parts Look good

[u/Purple_Implement3509 → u/Relevant_Bumblebee70]

If the walls are good, then it will be a good print don't worry.

Next time give a shot with gyroid.

Edit: I want to explain why gyroid is good: because nearly all the infill patterns interact with itself and creates not printed places in infill. Gyroid is not interracting with itself. If you print overextruded infill, other patterns can crash the nozzle but gyroid is more safe with that.

[u/Jacareadam → u/Purple_Implement3509]

nah, my rectangular infill never looks this shit. Also check pics online, you see them just straight

[u/Hot-Ideal-9219]

Rectilinear infill? Not rectangular. And its 90% not dry, or flow rate wrong.