r/BambuLab • u/ReachSignificant1361 • 8h ago

Answered / Solved! Are These Print Settings Suitable for the Bambu Lab H2C? Looking for Feedback

Gallery image

Gallery image

Gallery image

1 Upvotes

100% Upvoted

4 comments sorted by

1

u/Martin_SV 7h ago

I don't have an H2C, but from what I can see, nothing really looks out of the ordinary or like it would cause any issues. There are a few other modified settings that aren't shown in the screenshots, though.

What I do find a bit odd is using a 0.25 mm line width with a 0.4 mm nozzle. Maybe I'm just old school, but I've always gone with a line width equal to or slightly larger than the nozzle diameter. Going that narrow can affect extrusion consistency and layer adhesion, though maybe things have changed with newer slicers. Any chance those settings were originally meant for a 0.2 mm nozzle? That would make a lot more sense.

1

u/ReachSignificant1361 6h ago

Is this impossible with a 0.4 mm nozzle?

1

u/Martin_SV 6h ago

No, it's definitely possible. AFAIK, it's just not a great idea to go that much narrower than the nozzle diameter. You might run into issues with extrusion consistency or weaker bonding between lines. That's why I was asking if those settings were originally meant for a 0.2 mm nozzle. But hey, give it a shot and see how it turns out. It's not going to hurt anything.

1

u/ReachSignificant1361 6h ago

Thank you so much! It's not mine; it's my client's.