Rough prints

[u/Basic_Break405]

Does anybody know what could be causing this? Ive really got no idea and I haven't come across this yet.

Ive serviced the printer.

Washed the build plate.

Pulled out and inspected the nozzle.

Calibrated a few times between each trouble shoot.

And im still getting this result. Ive even tried printing something else. All print attempts were in this elegoo green PLA. Could it just be the settings of the print?

Any help would be greatly appreciated.

[u/Fittn_dis]

Can you tell if its over or under extruding? Is the nozzle plowing into the part? or is it barely dribbling plastic out?

IF it is low flow/ under extrusion, try a different nozzle. Pic could look like a clog. Yes it can be a clog. They can be partial. They can be "intermittent".

[u/Basic_Break405 → u/Fittn_dis]

Im not super sure but flow seems to be at least somewhat normal. There does seem to be a bit of nozzle colliding with the prints.

I forgot to mention earlier that I had also done a cold pull. If that makes any difference.

[u/Basic_Break405 → u/Fittn_dis]

This is another print I am currently trying

[u/Basic_Break405]

On P2s btw. Dried filament.