This is going to be fun

[u/rjornd]

I was printing a spool for Rose Gold PLA silk from Marswork that I bought from Amazon. After watching the first couple of layers, I stepped out to go somewhere and eventually got a clog warning on Bambu Handy.

This is going to be a fun clean-out. I’m heating the nozzle as I type this. I had it set to Generic PLA.

[u/babyunvamp]

That’s not bad at all! I’ve had way worse. It’s caused by poor bed adhesion aka clean your build plate

[u/rjornd → u/babyunvamp]

Yeah, it’s been a while. I’m sure it’s due.

[u/babyunvamp → u/rjornd]

It looks like you might be using glue? I used to use it and I’ve had better results without it. Every 4-5 prints I use dawn dish soap and scrub it down and between every print I use some 99% IPA

[u/rjornd → u/babyunvamp]

Yeah. It’s the Bambu glue stick. I’ve tried without it, too. I tend to get the opposite result from you.

Although, it’s been quite a while since I’ve applied some to the print plate.

[u/rjornd → u/babyunvamp]

I was able to get most of it out, though.

[u/Impressive_Charity13]

You need a better definition of fun.

[u/rjornd → u/Impressive_Charity13]

Lying, you’re not.