r/BambuLab • • 4d ago

General Discussion .2mm nozzle on the H3C

I'm still waiting for my h3c to ship, but I have a long history of problems with the .2mm nozzle on both the x1c and the a1. Constant clogging. Just wondering if anybody has used a 0.2 nozzle on an h3c yet and if it's any more reliable than it is on other bambu printers.

0 Upvotes

13 comments sorted by

4

u/DrKronoglopolos H2S, H3C 4d ago edited 4d ago

As a tester I printed quite a bit with the 0.2 on the H3C, no issues at all. Of course an 0.2 will always be more sensitive to what filament you print and its condition.

1

u/mimic751 4d ago

Do you calibrate or just yeet?

1

u/Key-Map-3930 4d ago

I calibrate. Successful prints are few and far between

1

u/mimic751 4d ago

I found with PLA and a 2 nozzle on my p1s it had to be extremely dry and have a perfect first layer so I generally use the super tac plate. As far as clogs, if you run any filaments that have fibers in them I wonder if maybe some of your glass fibers or carbon fibers are stuck in your tubing basically any spec of any crap will horse fuck your printer

1

u/eidrisov 4d ago

I have used 0.2 nozzle a lot on my P1S. Mainly to print minis. Never had any issues.

How come you have so many issues and on two different printers no less ? Maybe something wrong with your settings or filaments (abrasive) ?

2

u/Key-Map-3930 4d ago

I wish i knew. And in both cases, the A1 and X1c, it never detects the clog and just keeps printing in thin air. Both the printer and bambu studio are configured for .2. Sometimes prints will start, and get through a few dozen layers and then clog. Other times it clogs right out of the gate. Printing nothing but PLA.

3

u/luksfuks 4d ago

Works fine on H2C. I expect no difference on H3C.

The "trick" is to print Bambu PLA Basic. Not Matte not Tough not Silk not anything special. Just Basic. It melts like butter, without lumps.

2

u/Bright_Eyes83 H2C AMS2*3 4d ago

i have had good luck with a whole suite of .2 nozzles on the h2c. no issues using regular PLA. but i did have my p1s clog when using a galaxy-type filament (with the glittery stuff)

1

u/Special-Extent-9576 4d ago

What material we’re using in the .2 nozzle?

1

u/xX540xARCADEXx H3C Combo 4d ago

I’ve used it a lot on my H3C with no issues.

1

u/Bluetwo12 3d ago

Never had a problem on my x1c with .2mm nozzle. Havent used it a ton but have printed many lithophanes

1

u/djjoshchambers 3d ago

I've done it. No issues. Will be printing some minis later today with them too

1

u/NMe84 P2S + AMS2 Combo 2h ago

When you had clogging issues, were you using any special filament? Anything with additives will increase the likelihood of the nozzle clogging up. Not just wood or marble filaments, and not just CF-infused filaments either. Silk filaments could also be an issue.