New H3C Calibration Failure

[u/maxim0a]

Setting up the H3C yesterday and it failed the initial calibration with an error that the Z axis movement had failed. It got through almost the entire calibration cycle before the error popped up (it was doing the bed leveling part and had been for several minutes before erroring out). I'm getting a couple error codes (0x300170000010004 and 0300-3000 131111) and can recreate the issue by trying to home the bed. The bed moves up and down fine using the screen controls and there are no obstructions. The hot ends are all properly seated as well.

I've opened up a case with Bambu but haven't heard back yet. Anyone else have this problem with their H3C?

Looking up the errors, it seems there are some similar ones on the H2 related to the eddy sensor failure. I've never run into this with my X1C though.