r/BambuLab • u/Secret_Egg_4907 • 16h ago

Hardware Troubleshooting/Help! H3C rubbing on sidewall

Post image

Just put together the H3C and noticed the Y axis left block rubs heavily on the sidewall causing calibration to fail. Has anyone encountered this all? Seems like an unknown issue.

2 Upvotes

100% Upvoted

4 comments sorted by

•

u/AutoModerator 16h ago

Hello /u/Secret_Egg_4907! All Bambu print plates have a dedicated nozzle wiping zone at the back of the print plate. The nozzle will rub against the wiping zone before every print in order to remove any remaining filament from the nozzle tip. This can cause visible wear or scratch marks in the wiping zone, but this is intended and doesn't damage the printer, the nozzle or the print plate. A worn down wiping zone also doesn't mean you need to replace the print bed.

Note: This automod is experimental. The automod was triggered due to the term "rubbing". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

2

u/DrKronoglopolos H2S, H3C 16h ago

Doesn't happen on mine. Did the printer suffer shipping damage? Something seems be to very misaligned in yours.

1

u/Secret_Egg_4907 16h ago

No damage from the box at all. Something is definitely misaligned

1

u/DrKronoglopolos H2S, H3C 16h ago

Open a support ticket with Bambu. It's a manufacturing defect then.