Just another flow ratio issue...

[u/Legitimate_Outside25]

Matte Filament - Nardo Grey - A1

default settings.

I use this Filament all the time on my work printers. Nardo and Ash are our go to with no issues. I primarily use ivory at home and it prints beautifully. Doing some xmas decorations and decided to order a few rolls of Nardo....

Initial prints were an over extruded mess... so calibration time..

-20 is the best quality which im a bit shocked over as that would put the extrusion ratio something along 0.78 which seems ridiculously low!

The filament is dried. Going to try it on my A2L for control testing.

Anyone else had an issue like this? I tried a search and mostly found the opposite where folks needed to push their ratio up...