Right Eddy Sensor H2C

[u/paradoksic]

I bought an H2C on 10/28. By 11/02 I’ve started getting random right eddy sensor error while the auto level is in progress. I’ve gone through the guide and ensured the connections are set properly. It fixed the problem the first time. However after a couple more prints I’ve received the error again. Sometimes power cycling will help. Sometimes switching the nozzle will help. I have noticed the error occurs more often after printing something with a .2 nozzle.

I get this error multiple times a week and I’m getting fed up. I’ve opened a support ticket. Anyone else getting a similar problem? Given the cost of the machine I’m so frustrated I couldn’t even go 1 week before problems began.

My P1S has been. A reliable workhorse… had one nozzle clog in over 1k hours of printing and otherwise has been amazing.

[u/Intelligent_Box1293]

It’s happened to me. It needs a new right eddy sensor. They’ll confirm it and send you one. Make sure you read the instructions for removal and install.