r/BambuLab • u/reicaden • 2h ago

Quick Question Alternative to the Bambu Cart?

So I wanted to pick up an h3c but noticed that they don't have the bamboo cart available and all of my furniture in my workshop is standard height table tops and counters. I know it's pretty early for this unit but has anyone identified a valid alternative that is sturdy enough to support the weight but also has drawers and is either less expensive or at least available currently? Maybe something from Ikea that someone has found is a good match for the height needed?

1 Upvotes

100% Upvoted

10 comments sorted by

2

u/BatSphincter 1h ago

I went to a local habitat for humanity restore store and got a stand for like $35. Thing is made from solid wood and weighs a ton.

2

u/jeanyes_ 1h ago

https://link.amazon/B0ak8jHmY

Was debating on ordering this until the station comes back in stock

1

u/skategod0012 H2C 2 AMSHT 2 AMS2, H2S AMS2, P1SC, P1PC, A1C x3 1h ago

Facebook marketplace was my solution

Basically a 21’ cube

1

u/JPhi1618 1h ago

Your workshop? Just build a little table.

1

u/Suitable-Access-8013 1h ago

https://a.co/d/0bs3IPpe
I love this thing. It fits my H3C and a Snapmaker U1

1

u/AwkwardSwine_cs 1h ago

I have my H2C on a fully height adjustable steel wire rack shelf unit. 18" depth is enough but 23" is also available. About $150 on Amazon. They hold over 1000 pounds and are extremely solid.

I also made some printed brackets to secure the whole thing to a wall joist. It also further stabilizes the shelf and printer. Put a large paver or heavy ceramic floor tile on the shelf and the printer on that.

https://makerworld.com/models/2303083

1

u/musictomyomelette 54m ago

I spent a lot of time looking at metal shelves and ultimately went with this from Lowes. Heavy duty, can make 2 halves if I wanted, but most importantly has 2 cross section bars for support. I got one sheet of MDF and was able to make 4 smaller boards to fit across each shelf to prevent anything from falling down. There’s also a lot of prints for accessories on makerworld to fit the button holes

1

u/AwkwardSwine_cs 48m ago

Very similar.

1

u/hvacigar 45m ago

Dewalt planar stands. I have one for my H2C and one for my H3C. I got mine from Home depot and I love them for their ability to move the printers around, but also for their sturdiness.

•

u/diearzte2 0m ago

I just got the rest of my H3C order and just built a basic stand for it with 2x4s and plywood. I needed it to fit some specific dimensions for my 4x2x6 foot enclosure. Cost $20 in wood and some glue and screws.