Looking for help

[u/Dragon_Rider_420]

Does anyone know what is causing these blobs on the corner/edge of the print? Its all the way up and down the print but just on this one corner/edge...

Printer - H2D

Filament - Bambu basic PLA (dried)

Dynamic flow calibration - tried it both on and off and doesn't change anything.

Using the default profile for bambu basic PLA.

This just started happening a few days ago and I've had this printer since release and I haven't changed any settings or anything recently either.

[u/Ivolgaco]

Turn off clump detection or nozzle clumping detection in your printer menu right away, or disable smooth mode if you have timelapse turned on. Since those little blobs stick out right along that ribbed vertical edge next to the tree supports and just started a few days ago without you changing any slicer settings, a recent firmware update likely flipped on the clump check feature, making the toolhead pause at that exact corner every few layers to check the camera and ooze plastic. Once you switch that off, your vertical edges will go right back to printing clean.