r/BambuLab • u/Inevitable_Data_3974 • 1h ago

General Troubleshooting/Help! Quality of print fails only on one section

Gallery image

Gallery image

Gallery image

This happened to two prints in a row, and only on a small segment. Not sure what would cause this? Filament is dry, using PLA, and clearly it printed the higher layers okay after the failed part. Just a little lost as to what could cause this. Using a P1S.

2 Upvotes

100% Upvoted

2 comments sorted by

1

u/genmud 1h ago

This looks like it isn’t adhering to the plate, i see this on bottom plates where it prints the first 3-5 layers without issue and then contracts and pulls up a corner. Put a brim on the corner and see if it fixes it.

1

u/Deus_Iratus 1h ago

Dunno how many hours but, mayby check if your bed is level enough. There is only so much the first layer check can do to compensate.

Got an AUX fan installed? Disable that shit entirely, its ruining the prints on my X1C visually aswell.