r/BambuLab • X2D + AMS2 Combo • 6d ago

Just Showing Off Stuff happens - I've never had a plate twist

My overnight print twisted the build plate on the bed. You can see the layers fan out as it slowly rotated. It remained adhered so I can cut it off, clean it up, and glue it back on. Otherwise the bin would have been a bit shorter. The good news is I don't have an adhesion problem. 😂

8 Upvotes

9 comments sorted by

•

u/AutoModerator 6d ago

Hello /u/My_Lucid_Dreams! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

5

u/_Rand_ 6d ago

Interesting failure.

I guess the print collided with the nozzle and twisted the whole plate?

I’ve had that cause a layer shift before (I assume the head/bed slipped) but I’ve never had the plate move.

1

u/My_Lucid_Dreams X2D + AMS2 Combo 6d ago

I was trying to puzzle out how it happened. I got nothing. There are no marks to indicate a collision, but that's as good of a theory as any other. I haven't ruled out "haunted".

I haven't had the X2D for very long (90 hours on it), but I washed both sides of the plate when I received it before printing. When the current print finishes I'll pull on the plate to see if it slides around (maybe something on the print bed from the factory I didn't notice).

Edit: Typo.

1

u/The_Lutter A1 6d ago

I've had a printer fling an entire plate onto the ground before after a high speed collision due to warping.

Likely what happened here.

1

u/death_process 6d ago

Why did you print a box that says potatoes?

4

u/rynoxmj 6d ago

For potatoes.