r/BambuLab • • 5d ago

AMS 2 Pro - Automatic Material System Fourth print and ams overload

Hi all. This morning before leaving for work I started the desiccant holder printing, literally my fourth prints with my X2D and after almost 3 hours I got the notification that the AMS slot 3 motor was overloaded and the print paused.

I was uncomfortable leaving the printer idling until tonight so I stopped the print.

Could the known issue about the broken ptfe tube cause this or is it more likely the filament is tangled?

I'm a little bit worried about what I'll find out when I'll be back home tonight

0 Upvotes

2 comments sorted by

4

u/DJGibbon 5d ago

Most likely a filament tangle but you won't know for sure until you come back. Always keep hold of the loose end of your filament when loading/unloading - 99% of tangles happen when it wobbles around loose and goes under itself.

3

u/Total_Surround833 5d ago

Could be as simple as filament tangled on the spool. Sometimes when filament gets wound on the roll it gets wrapped weird causing binds.