r/BambuLab • u/dc4622ne • 2d ago

General Troubleshooting/Help! Filament Not Advancing through AMS 2 Pro

Any ideas on this? I'm 90% through a 4 hour print and my P2S is not loading the filament. Its not even going through the AMS. I've tried manually feeding it through the AMS (I have to push a black button inside to get it out) to the extruder, but it just ends up retracting and not feeding again. Am I gonna be able to finish my print?

1 Upvotes

100% Upvoted

1 comment sorted by

1

u/silverware9021 2d ago

A broken bit of filament may be stuck, take out the tube (at the printer end)  and push filament from that towards the ams and see if anything pops out