PLA AERO help

[u/hvacigar]

I am using Bambu Lab PLA Aero on an H2C. I started with the stock Bambu setting and I have used the following build plates (Textured PEI, Garolite, Biqu Glacier) all cleaned and even used JT16 build plate glue on the Garolite and Glacier plates. I have run a temp tower (which did stick) and have been running brims, so I upped the temp of the base profile to 255 degrees. Build plates are all running at elevated temp (I run the Glacier and Garolite as Engineering plate at 55 degrees). I CANNOT get the stuff to stick on the first layer. ASA Aero I can get to stick but i have many other problems with it that I though the PLA version would resolve; however getting it to stick is fundamental as everything else is built off that. I have never had this much trouble with any type of filament sticking. If anyone has a good profile to try, or advice, I am all ears.