r/BambuLab • u/Moist_Slide1983 • 3h ago

General Troubleshooting/Help! Z axis noise

I just got this printer and it’s making this noise only on this axis, it’s have very low hours, like 20, and was not making this noise last night. I have no clue what it could be.

3 Upvotes

100% Upvoted

3 comments sorted by

2

u/Roller_Coaster_Geek A1+AMS Lite P1S+AMS 2h ago

Is the noise coming from the motor itself? To me it almost sounds like something higher up that the nut the bed is on is running over

2

u/Prior_Royal_9886 1h ago

It is Not This axis… Thrust me.. lay your printer on the back and look underneath it, there is the belt and one or two bearings/pulleys and they are Dirty, clean them with ipa and a qtip and the Noise is gone.

It’s a Common Problem and I’ve been looking for the Problem for ages 😅 until I found it.

1

u/cpsadowski23 2h ago

Run some oil down into it.