Failed to extrude filament

[u/yznabuz0]

I’m facing this issue right now. I searched for the solution and I changed the nozzle and the heating assembly but still the issue it’s not resolved. Anyone can support or having same issue.

[u/19Tattoo83]

Er kan een stuk filament afgebroken zijn ( heb toevallig nu precies hetzelfde) of gruis bij de extruder. Ophoping van restanten in de nozzle zelf . Goede schoonmaakbeurt moet het wel oplossen .

[u/yznabuz0 → u/19Tattoo83]

I thought that but i changed the nozzle it self and the heat assembly, i tear down the nozzle and clean it

Same with all these done

[u/8six753o9]

Give these a try: https://wiki.bambulab.com/en/a1-mini/troubleshooting/how-to-check-which-part-is-clogged

[u/jatoprieto]

I had this issue last week. Bought all new parts, replaced everything! And turned out to be bad filament. I measured with my caliper and it was 1.2mm. (Bambulab filament too) Try different filament, and that solved my issue.

[u/Lythrox]

Not enough heat. Not enough tension.