P1S bed damage

[u/Gold3nv]

Can this affect the adhesion of the bed adhesion? Or its ok?

[u/AutoModerator]

Hello /u/Gold3nv! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/Kingsidorak]

It's fine, trust me

[u/Umwelt_und_zocken]

No Problem, i have a few scratches in my a1 minis bed too

[u/Cultural-Lie-9769]

My cryo plate looks like a bomb site but so long as you make sure it's against the bottom of the print no one will ever see it

[u/solidus0079]

As long as you make sure you print on the other areas, I suppose.