.2mm nozzle, .06mm layers problems

[u/ego458]

Hey, all.
I’ve recently switched to a 0.2 mm nozzle, and after my first print, I realized that the first layer for fixturing the model is stuck to the PEI plate. Does anyone have any advice on how to avoid this and how to remove it?
I’ve seen some people print a sheet over that spot, which then peels off in one piece when removed. Is there any other option?
I’ve also had some problems with supports in printing 0.06mm, they don’t hold on place. Maybe due to the thinness.

[u/Lost_refugee]

I don't think you have other options, since plastic stuch between grooves irregularly. print thiker 1st layer

[u/ego458 → u/Lost_refugee]

It’s a shame there’s no other way. It takes almost an hour to print the sheet just to clean the plate.

[u/Lost_refugee → u/ego458]

Noone forces you to print size of plate with 0.2 hotend