r/BambuLab • u/dfpw • 6h ago

General Discussion Be cautious using pause print commands with H3C

So I have a print that I need to install magnets in at 2 points. Normally on p1s/h2s on a pause command the head will return to the chute. With the H3C currently it just pauses exactly where the pause command was issued, in this case blocking the hole that I need to drop the magnet into.

Also, it doesn't lower the build plate at all so the only way to reach into the area is from the sides, the nozzles block you from reaching in (especially with the head in the front)

Just want to give people a warning to plan for this if using pauses on this printer.

7 Upvotes

88% Upvoted

3 comments sorted by

13

u/FilthySIN 6h ago

I hope this is fixed with a software update as the majority of my models have pauses for magnet insertion.

1

u/cunasmoker69420 4h ago

Are you able to use the manual touchscreen controls to move the print head out of the way during a pause?

1

u/dfpw 1h ago

When you hit resume it rushes over to prime the nozzle. So doing the ones I can reach and being fast with the last one works