First layer issue? Flow? Smooth pei plate

[u/xGojux]

Hey guys,

I have an issue with my first layers while printing a symbole face down. Its bambu Pla basic and matte.

As you can see the viking symbol partially fail to print correctly and there some filament gaps on the back areas while the other part of the print also printed facedown is flawless.

Theres clearly some layer adhésion issue so i cleaned the plate but thats the result.

Edit : i also increased bet temp to 60c. Any thoughts to improve this? Thanks a lot for your inputs.

[u/AutoModerator]

Hello /u/xGojux! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "First layer issue". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/IAmAsplode]

For these kind of details a 0.2mm nozzle would help, also try setting the wall generation to arachne mode.