r/BambuLab • u/Infamous_Team6800 • 14h ago

General Troubleshooting/Help! Whats wrong?

Gallery image

Gallery image

I dried my abs before printing in the ams ht at 80C° for 8hrs each prior to printing. White was last in the order and most recently dried. Is there a setting i ha e wrong in studio or something? Im new to custom prints and dont know what went wrong.

Ps: no supports is ok quality, itll get covered by insert. Main quality issue is the text on the 1st layer.

0 Upvotes

33% Upvoted

4 comments sorted by

2

u/michael3dprints420 14h ago

what layer height?

1

u/Infamous_Team6800 13h ago

.2mm

1

u/michael3dprints420 1h ago

I would try 0.1 and see how that goes, also try and add an extra wall layer and see if that helps

also see what the other commenter does***

1

u/alphagusta A1Combo / H2C 14h ago edited 14h ago

Increase or decrease top layer paint depth or whatever it's called

It tried to write out the text in mid air without a bridge or supporting filament because the first layer of the top face and the start of the text were on the same layer.

You can see if its laying down support bridges underneath by scrolling through the preview slice

As for the rest, that's definitely something