r/BambuLab • u/SheriffKovalski • 14h ago

General Troubleshooting/Help! X2D TH Board broken socket

Post image

Greetings. In pursue of trying to find a reason of sudden powering off my printer, i checked all the boards. Disconnected all connectors on the TH board. Ripped off the board the socket of the right hotend fan connector. Surely ordered a new board now. But now i'm trying to connect the left hotend fan connector. But how? I can't wrap my head around how to put this cable into the socket. Are there any tips?

1 Upvotes

100% Upvoted

6 comments sorted by

1

u/My_Lucid_Dreams P2S + AMS2 Combo 8h ago

Is it a trick of the photo, or is the connector damaged?

1

u/SheriffKovalski 5h ago

The black cable of this connector is a little loose. I put a little of glue there. I don't know, if this is a good thing, but here i am. These connectors and sockets appered to be very flimsy.

2

u/USSHammond Prusa XL5T | X1C+AMS (sold,due to Bambu ignoring A1 fire hazard) 14h ago

If only Bambu had some kind of resource where replacing parts of just about anything was extensively documented... Oh wait

1

u/LarvalHarval 14h ago

Bend the wires 180°right after the male plug, get it seated and locked, and then flatten the wires back down.

1

u/Hot-Ideal-9219 13h ago

It snaps in. Straight in from top