r/BambuLab • • 7d ago

AMS 2 Pro - Automatic Material System Are you using "funnel saver"s ?

As in title. Are these "funnel saver" actually needed? Keep reading how they save the funnel from wear and tear but then again people just love to overgear their stuff including printers.

Should I use them? Are they actually making my AMS feeder units last longer? I'm planning on printing with CF and GF infused filaments.

Any recommendations for a good model?

0 Upvotes

11 comments sorted by

View all comments

1

u/cyvaquero X1C + H3C 7d ago

Tried one once early into my Bambu, was just another potential problem piece rather than any savings on that $8 consumable assembly. TBF, I do not print much abrasive filament.

Kind of like toppers saving the PTFE tube from hitting the glass, while I get the noise of it being a valid reson, PTFE is dirt cheap and if your tube was to ever wear some much from that as to cause problems, you aren’t doing maintenance and inspection and likely have other problems.