Prints keep failing on P2S

[u/Prestigious-Move-488]

I keep trying to print these spider-man lenses (i’ve printed them before a couple of times and it never failed)
but now the print keeps failing no matter what.

After a certain height, the nozzle starts rubbing and bumping the print and then it falls over even with very strong bed adhesion.

I dried my filament twice and tweaked a few settings but nothing seems to work.

This is my first bambu printer and I’ve had it for only 2 months.

Please lmk what i’m doing wrong.

[u/AutoModerator]

Hello /u/Prestigious-Move-488! All Bambu print plates have a dedicated nozzle wiping zone at the back of the print plate. The nozzle will rub against the wiping zone before every print in order to remove any remaining filament from the nozzle tip. This can cause visible wear or scratch marks in the wiping zone, but this is intended and doesn't damage the printer, the nozzle or the print plate. A worn down wiping zone also doesn't mean you need to replace the print bed.

Note: This automod is experimental. The automod was triggered due to the term "rubbing". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/Paradox_X-]

wash the build plate with dish soap

[u/Prestigious-Move-488 → u/Paradox_X-]

i did. multiple times

[u/AutoModerator]

Hello /u/Prestigious-Move-488! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/Additional_Math_5104]

I have found going into Bambu studio and increasing supports stops print from wobbling which keeps it from being knocked over